1
General Mach Discussion / Using a Stepper motor as a spindle motor
« on: June 01, 2011, 03:24:58 PM »
Hi I was wondering if MACh3 supports using a stepper or servo motor as a spindle motor?
My current need is for using it to cut threads on a Sherline Lathe.
do you need to purchase any plugins for this or is it built in?
Thank you for your time.
My current need is for using it to cut threads on a Sherline Lathe.
do you need to purchase any plugins for this or is it built in?
Thank you for your time.