Topics

1

Feature Requests / Manual Spindle Calibration *PLEASE*

« on: May 29, 2011, 01:03:15 PM »

My mill does not send a tach signal back to the control computer but the spindle speed is visible on the motor controller.
Since I dont have a tach signal I cannot auto-calibrate the spindle.
I wish there was a way to manually enter the spindle speed vs PWM %.

I am sure this feature would be widely appreciated!

Is there a way to manual edit linear.dat or something I can do to achieve manual calibration?

Thanks for a great program!

2

General Mach Discussion / Spindle Calibration by Manually Editing the .xml

« on: May 28, 2011, 09:39:18 PM »

My mill does not send a tach signal back to the control computer but the spindle speed is visible on the motor controller.
Since I dont have a tach signal I cannot auto-calibrate the spindle.
I wish there was a way to manually enter the spindle speed vs PWM %.

I think it could probably be done in the mymill.xml file.

Does anyone have any experience with editing the xml to achieve this?