Topics

1

General Mach Discussion / Aspire 4.0 post processor for ROMAXX HS1

« on: February 11, 2014, 10:13:10 PM »

Is there anyone that has made a post processor for Vectaric Aspire for a ROMAXX HS1?
I spoke to Ron at romaxx and he said the Vectaric was going to write  one but thats been
long time ago.I would do it myself but I am not that smart!Any help would be appreciated.
              Thanks Dave Mcadams

2

General Mach Discussion / how to cut text in reverse (on a acrilic sign)

« on: June 08, 2012, 05:55:44 PM »

Can anyone tell me what I need to alter to be able to cut a logo in reverse on lexan so it reads correct on the smooth side.Thanks Dave.

3

Share Your GCode / I NEED THE KISS LOGO IN G CODE

« on: May 08, 2012, 08:15:38 PM »

IF ANYONE HAS THE KISS LOGO IN G CODE THAT WOULD BE GREAT.THANKS

4

General Mach Discussion / part size in tool path

« on: April 30, 2012, 11:06:57 PM »

How do you change the part size in the tool path display?I am just learning and I have some tool paths where the part is very small and some where its of the screen.Thanks.

5

VB and the development of wizards / I am having trouble with loading the engraving wizard

« on: April 19, 2012, 12:57:35 PM »

I can not get the engraving wizard that comes in mach to load code to my run screen?Before I had my mill on line I could get it to run a simulation but now that I have my machine on line I cant get it to load any g code.What am I doing wrong?THANKS Dave.

6

General Mach Discussion / 1st time build having problems spinning motors!

« on: November 20, 2011, 01:21:03 AM »

I need help!I have a kelig 3 axis system and mach3.I wired it as in the attachment and set mach 3 with the set up guide.The motors have power as they cant be spun by hand.But when I try to jog the software runs the dro but the motors stay.Can someone set me in the right direction.Thanks Macatoms.