Topics

1

General Mach Discussion / where is my calibration.....

« on: September 28, 2007, 12:20:10 PM »

I think I had an older rev but I thought I remembered that there was a spot in motor tuning where I was able to type in go 2inches then measure how far my machine really went and it would figure out how many steps it takes to get there. This would be a great addin if it is no longer available.

Please help

Coog

2

General Mach Discussion / What is the minimum PC required.

« on: August 16, 2007, 12:12:56 PM »

To run a 4 axis machine what is the minimum PC requirements. I will have XP installed but is 256mb ram enough is a P3 900mhz enough? I would be only running Mach3 nothing else on this machine.

Coog