Guest
Show Posts
1
General Mach Discussion / Artcam to Mach3 -partial file missing
« on: May 15, 2011, 03:58:51 AM »
Hi I was wondering if someone can lead me in the right direction.
I'm having a few issues when I post Gcode to mach3 from Artcam.
I'm sure its just something simple, but it seems to only send through half the file.
For example, if I'm doing a 2mm deep engraving of the name 'Frank', it will send through 'ank',
I'm a bit stumped, as its all one tool path, it just breaks it in half for some reason.
It has also done it occasionally with the import of Hpgl files, send through say 60% of the file.
But most of the time its working great.
Thanks in advance,
Ryan.
I'm having a few issues when I post Gcode to mach3 from Artcam.
I'm sure its just something simple, but it seems to only send through half the file.
For example, if I'm doing a 2mm deep engraving of the name 'Frank', it will send through 'ank',
I'm a bit stumped, as its all one tool path, it just breaks it in half for some reason.
It has also done it occasionally with the import of Hpgl files, send through say 60% of the file.
But most of the time its working great.
Thanks in advance,
Ryan.