Hello Guest it is March 28, 2024, 05:13:59 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ben wood

Pages: 1
1
General Mach Discussion / Asolutely dumbfounded guy!????
« on: May 09, 2011, 01:56:57 AM »
First Id like to thank everyone who fields these questions. I've found amazing info in the various forums on line. Enough info in fact to build a nice little 18" x 30" x 6" router. It's turned out great, I've even cut a couple of parts, but i have a nagging problem. I'm trying to get my motors to run smoothly and have been experimenting with a lot of different speeds and acceleration to try to acheive this. Whats puzzling is that if have the motor tuning dialog open I can get them to move smooth as butter at top speed (25,000 mhz). But then when I close that window and am jogging the motors they run really poorly. I'm running a g540, mach 3, 48v power, 12 amps, and 381 oz in motors. If anybody would like the specs on the motors I can supply those also. I bought them through keiling, for what it's worth. Thanks all for taking a minute to read this. I've spent hours searching for the solution, and am finally throwing in the towel and asking for help. Thanks again!!!!

Ben Wood

Pages: 1