Hello Guest it is May 30, 2020, 11:05:16 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Mattwindy

Pages: 1
1
General Mach Discussion / Help w/ cnc plasma issue
« on: May 01, 2011, 11:20:27 PM »
Having some issues I am hoping you all can help. I am running my software on a cnc plasma. If I run the g code without the plasma it runs clean. The minute I run with the torch the machine takes on a mind of it's own. However if I run without the torch, and manually fire it mid code it runs flawlessly? Could this be an ground/noise issue? Controller is a c and cnc unit.

Pages: 1