Hello Guest it is March 28, 2024, 03:19:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ridesideways

Pages: 1
1
I'm having trouble with Mach3 (version 2.0) during the loading of the G code file and Mach3 does a simulated run to test the progrom.  Basically it complains with the following status message: "Radius to end of arc differs from radius to start on line number 1940".  Does this message from Mach3 seem legitimate based on the G code snippet below?  Or is possibly the problem with my CAM software (RhinoCam with post for Mach 2) generating invalid G code?

Here is the snippet that Mach3 is complaining about:
N1920 G01 X0.9810 Y1.5748
N1930 G01 Y2.6077
N1940 G02 X-0.9817 Y2.6085 I0.0000 J3.5151
N1950 G01 X-0.9829 Y1.5239

I'm very stuck right now-- I've never had this problem before with RhinoCam and Mach3. Thanks in advance for any advice you can provide me.
-Eric

Pages: 1