Hello Guest it is March 28, 2024, 09:41:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - ailmik

Pages: 1
1
General Mach Discussion / Troubleshooting
« on: September 21, 2011, 12:14:54 AM »
Hi Everyone,
I run Mach3 Mill and I'm having an intermittent problem. How do I go about troubleshooting the machine just stopping at any particular part of the code?  I can go through and do a full practice cut in MDF and then try the exact same code in decent timber and the machine will stop at a random spot. I can tell the machine to "run from here" press cycle start and it runs through the code until it gets to the same spot and stops again. If I restart Mach it will then run the whole code without a hitch. The machine can cut for several hours at a time with no problems and then it may only be just 10 minutes into another job and then fail.  Any advise on what I should be looking for would be appreciated.
All the best
Kim

Pages: 1