Hello Guest it is March 29, 2024, 07:26:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - terrapigui

Pages: 1
1
VB and the development of wizards / is possible vbscript for dobutton(23) ?
« on: September 01, 2017, 04:02:32 AM »
Hi
sorry for my bad english.
i need a equivalent code vbscript for dobutton(23) for modify the feedrate when active signal trough inductive sensor.
i need improve accuracy
is possible?
thanks

Additional Information...

After a long time, I have had to restart the cnc I made a few years ago. I am using the mach3 and I have adapted capacitive sensors on the X axis and the Y axis, I use them as a reference to position my mandrino the one Point x = 0 and = 0 that I get when I run the ref all home button.
The problem is that I need a maximum precision because I use it to mill pcb boards, I have noticed that when I stop motors, or I interrupt the program and I want to start again, when I return to give ref all home it returns in theory to the point x = 0 and = 0, but in reality there is a margin of error, so doing another pass ruined the work done.
I have come to the conclusion that when I refer to 0 with the sensors, the feedrate speed is high to have an accuracy, so I want to adapt a script that does the following:
When sensor X is detected (the sensor led lights up), stop and then move very slowly until the sensor led is turned off, the same with the Y axis.
Someone could lend me a hand with that script? I'm very stuck with the topic of macros and scripts.


2
Spanish / modificar script ref all home
« on: July 16, 2017, 02:32:33 PM »
Hola amigos
Después de mucho tiemo he tenido que retomar el manejo de mi cnc que fabriqué hace unos años.Estoy utiliando el mach3 y le he adaptado unos sensores capacitivos en el eje X y en el eje Y,los utilizo como referencia para posicionar mi mandrino el un punto x=0 y=0 que obtengo al ejecutar el boton ref all home.
el problema es que necesito una precisión máxima porque lo utilizo para fresar placas de pcb, me he dado cuenta de que cuando paro motores , o interrumpo el programa y quiero volver a empezar, cuando vuelvo a dar ref all home vuelve en teoria al punto x=0 y=0, pero en realidad hay un margen de error, por lo que al hacer otra pasada me arruina el trabajo realizado.
he llegado a la conclusión de que cuando se referencia a 0 con los sensores, la velocidad feedrate es elevada pra tener una precision, por lo que quiero adaptar un script que haga lo siguiente:
cuando detecta sensor X (se enciende el led del sensor) , pare y a continuación se desplaze muy lentamente hasta que se apague el led del sensor, lo mismo con el eje Y.
Alguien podría echarme una mano con ese script?. estoy muy pegado con el tema de las macros y scripts.
gracias

Pages: 1