1
General Mach Discussion / Scaling problem
« on: January 31, 2006, 11:38:31 AM »
# Newbie # Could anyone tell me why when I have converted a simple drawing
of about 6" x 8" to gcode, and then imported to mach2, the toolpath is a lot
smaller even if I change from mills to inches. Is the scale lost in conversion to
gcode or can I alter something in mach2.? Any help much appreciated.
of about 6" x 8" to gcode, and then imported to mach2, the toolpath is a lot
smaller even if I change from mills to inches. Is the scale lost in conversion to
gcode or can I alter something in mach2.? Any help much appreciated.