Guest
Show Posts
1
General Mach Discussion / Closed loop options?
« on: February 15, 2011, 03:48:35 AM »
Hello,
I have a purchased a Milltronics Partner 4 Milling machine and it has been stripped of the electronics all except the spindle motor. I already had some Allen Bradley AC servo amps and .73Kw motors for the axis that accept Step/dir and also +/- 10v for control.
I want to be able to have closed loop control and I was wondering what are my options I have seen the Ajax and the dspMC/IP control boards and I like them but I want to look at all my options before I descide.
Also like I said the machine had no servos so do you think the 1hp servos have enough power for this mill?
I will look into all suggestions and thanks in advance for the info.
I have a purchased a Milltronics Partner 4 Milling machine and it has been stripped of the electronics all except the spindle motor. I already had some Allen Bradley AC servo amps and .73Kw motors for the axis that accept Step/dir and also +/- 10v for control.
I want to be able to have closed loop control and I was wondering what are my options I have seen the Ajax and the dspMC/IP control boards and I like them but I want to look at all my options before I descide.
Also like I said the machine had no servos so do you think the 1hp servos have enough power for this mill?
I will look into all suggestions and thanks in advance for the info.