Hello Guest it is December 01, 2021, 02:54:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 60hdrider

Pages: 1
1
FAQs / motor movement
« on: January 27, 2014, 10:55:31 AM »
I have been using Mach 3 for a while now and my computer crashed. I reconnected another computer that I had been using to try my programs (simulating). I lost all my inputs and output configurations but that is not the real problem. I have gone thru the setup procedures and should have enough information for motor movement but do not. I can hear them react to commands but no movements. I do have them enabled in Ports an pins. Please help.

Bill

Pages: 1