Guest
Show Posts
1
General Mach Discussion / Motors will not spin
« on: March 27, 2011, 01:08:53 PM »
Hi everyone,
I just installed a Step and Direction Adapter Board from taig tools into a micromill 2000hd/le controller. I installed Mach 3 on to the computer and followed the video tutorial on how to configure it properly. My issue is......I can not get the motors to work. There is no power reaching them. The DRO in Mach 3 is working. I think my problem lies with the port or the port address. I have tested the pins on my printer port at pin numbers 25 and 3, 25 and 5, and 25 and 7. I get 0 voltage all the time, even when I'm jogging. Pins 10-16 have a constant 4.5v.
My port address is set up as 0x378. My question is..... when i open control panel, system, hardware tab, device manager, port, LPT1 and then click on the resources tab there are 3 different addresses in there. The first one says DMA 00. The second says I/O range 378-37F. The third says I/O range 778-77F. Is this where my problem lies?
Any help is appreciated.
I'm not a computer wizard by any means.
I just installed a Step and Direction Adapter Board from taig tools into a micromill 2000hd/le controller. I installed Mach 3 on to the computer and followed the video tutorial on how to configure it properly. My issue is......I can not get the motors to work. There is no power reaching them. The DRO in Mach 3 is working. I think my problem lies with the port or the port address. I have tested the pins on my printer port at pin numbers 25 and 3, 25 and 5, and 25 and 7. I get 0 voltage all the time, even when I'm jogging. Pins 10-16 have a constant 4.5v.
My port address is set up as 0x378. My question is..... when i open control panel, system, hardware tab, device manager, port, LPT1 and then click on the resources tab there are 3 different addresses in there. The first one says DMA 00. The second says I/O range 378-37F. The third says I/O range 778-77F. Is this where my problem lies?
Any help is appreciated.
I'm not a computer wizard by any means.