Topics

1

HiCON Motion Controller / Support synchronous with motion commands M10Px/M11Px for Mach3

« on: April 09, 2017, 05:18:26 AM »

Hello!
Does the HiCON INTEGRA controller support synchronous with motion commands M10P(output number)/M11P(output number) for Mach3 and M62 P(output number)/M63 P(output number) for Mach4?
Thank you!

2

CS-Lab / Support M10/M11 commands

« on: May 06, 2015, 05:27:19 AM »

Who knows if it supports M10/M11 and EXP0/EXP1 command?
I use CSMIO/IP-M and assign Output#5 signal to PORT10 PIN1. But command M10 (ActivateSignal(11)) or M11(DeActivateSignal(11)) does not work. OUTPUT1 change state if I select/deselect "ActiveLow", but not respond to command.
Thanks!!!

3

Promote and discuss your product / Neuron.THC Torch Height Control (plasma)

« on: November 30, 2013, 01:26:42 AM »

The Neuron.THC is a ARM microprocessor-based torch height control system which controls the torch-to-work distance of a plasma torch during cutting operations. The system includes a control module, plasma system interface module, interconnecting cables and optional operator control module.

-Works with all plasma cutting systems.
-Connect via Ethernet interface to Mach3 CNC  and controls Z axis directly. No additional parallel port or port multiplexing.
-All Parameters are set and displayed from Control Panel integrated in Mach3. Quick access and changing of all parameters.
-Unlimited number of cut profiles for different metal thicknesses. Quickly switch between profiles and the ability to quick edit them.
-No matter to set parameters in G-Code.
-Set point resolution - 0.25V
-Set point range - 25 - 250V
-Maximum control accuracy - +/-0.25V
-Voltage feedback (divider) - 1:20, 1:10 of Arc Voltage
-Buffered Step & Direction for direct interface to Motor Drive.
-All inputs are isolated and Simple wiring.
-Sample voltage mode - THC measures the voltage at the end of the AVC Delay and uses it as a set point for the remainder of the cut.
-Skip IHS mode - If the next starting point is within this distance of the end of the previous cut, the THC skips the IHS.
-Improved Jog  - the lifter initially jogs 0.25 mm. After 0.5 second, it begins continuous  motion at the IHS Speed. After 1.5 seconds, the lifter increases the speed to the programmed Manual Speed.
-Automatic control of ventilation.
-There are the relays on the board which produce Preflow during IHS and Pierce End signals. 
-Integrated diagnostic system informs the operator of the errors that occurred.
-Ability to work in trial mode without limitation functions until the end of the set value of the pierce count. Further work is possible after entering the activation code (for OEM manufacturer).
-Easy Software update using the utility NeuronFlasher.
-....... https://sites.google.com/site/thcneuron/neuron-thc-english