Hello Guest it is March 28, 2024, 10:15:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - daddog

Pages: 1
1
General Mach Discussion / feed rate button on program run screen
« on: May 13, 2012, 08:11:16 PM »
Sometimes I would like to be able to speed up or slow down my feed speed when using my router.  I assume that the Feed Rate button should allow me to do that, but it doesnt.  What do I need to do to activate this feature?  Thanks

2
General Mach Discussion / plasma not firing
« on: May 10, 2011, 10:18:52 PM »
I recently had to reinstall all of my software (sheetCam, Cut 2d, and Mach3) on the computer that runs my EZ-Router CNC.  Now, Mach will not fire the plasma cutter.  I can hit the TORCH button on the main Mach page and the torch will fire "manually", but it will not fire automatically.  The rest of the program runs fine, the torch touches off and follows the pattern of the part to be made, but torchdoes not fire.  The plasma unit is not giving any errors and there are no indications that anything is wrong, other than the torch not firing.  Any ideas?

3
General Mach Discussion / z axis problem
« on: March 15, 2011, 08:47:55 PM »
Due to material warpage or table eneveness, my z axis sometimes hangs on the part when making long moves (torch off) while cutting, causing the part to move.  How can I increase the height of the torch (z axis) during these moves?

Pages: 1