Hello Guest it is June 20, 2021, 10:07:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - davidc

Pages: 1
General Mach Discussion / Outputs activated by hotkey?
« on: May 11, 2011, 09:42:14 AM »

Apologies if this is a dense question, but I'm new to Mach3!

I've got a PC/Relay board attached to my LPT port, which activates relays based on an output on pins 2-9 (turn on pin 9 & a coressponding relay is activated)

I've assigned Output#1 to port 1, pin 8, and toggling active low on/off activates the relay as I want it to.

Is there a way to attach this to a keyboard hotkey? So for example pressing F1 switches output 1 on/off?

Many thanks,

General Mach Discussion / Stepper motor working in 1 direction only!
« on: March 15, 2011, 07:32:58 AM »
Hi All, new to MACH3 & CNC control in general, so hoping I've just got something silly wrong here!

I've got a stepper motor (Bipolar) connected to a Parker XL25 driver, connected to my PC & MACH3.

The driver can operate in 2 modes, Step/Direction, or Step+/Step- mode.

wired for step/direction, I have ports 1&2 on the LPT connected to the corresponding step/dir ports on the driver, but although the motor powers on I get no motion.

Someone suggested that by switching to Step+/Step- mode (there is a DIP switch on the driver to do this) and just wiring the Step- & Dir - pins on the driver together it would work.
Now I get motion in one direction only (presumably caused by the inputs on the Step+ & Dir+ pins, but lacking any input on the Step- & Dir - pins)
Is it possible to configure MACH3 to operate in this Step+/Step- mode, or any trick to get the Step/Dir mode working?

Many thanks for any help - much appreciated!


Pages: 1