1
General Mach Discussion / Screw Thread Pitch Control
« on: October 06, 2009, 07:00:54 AM »
I am currently retrofitting an Emco Compact 5 lathe to work with Mach3.
My plan is to monitor spindle speed but not control it dynamically from Mach3 and I've been wondering if that will be sufficient for thread cutting.
In other words does Mach3 dynamically control the velocity of the Z axis stepper motor to get the correct pitch regardless of spindle speed?
Thanks
Jim
My plan is to monitor spindle speed but not control it dynamically from Mach3 and I've been wondering if that will be sufficient for thread cutting.
In other words does Mach3 dynamically control the velocity of the Z axis stepper motor to get the correct pitch regardless of spindle speed?
Thanks
Jim