1
General Mach Discussion / softlimits
« on: January 28, 2006, 09:32:30 PM »
I am having a problem using softlimits.
My configuration units are metric. The X limit is 600 mm. Softlimits seems to work fine.
If I change units to inches on the setup page softlimits stops the X axis at .93
instead of 23.6 inches. Softlimits has shrunken my X axis by a factor of 25.4
--slow
My configuration units are metric. The X limit is 600 mm. Softlimits seems to work fine.
If I change units to inches on the setup page softlimits stops the X axis at .93
instead of 23.6 inches. Softlimits has shrunken my X axis by a factor of 25.4
--slow