1
General Mach Discussion / Mach3 and second parallel port card
« on: December 26, 2013, 03:57:09 PM »
I have been having issues with a second PCI parallel port card. I purchased the card from CNC4PC along with a MPGand the C22 card.
I installed the card on a Gateway PC runnning windows XP. The device manager shows the card installed and working. Device manager shows 2 I/O address, CD00 and D480. I have tried both with odd results.
When I entered the first address clicked apply Mach3 did not communicate with the card. I then tried the second I/O address and clicked apply and this did not work either. I then went back and input the first I/O address click apply and magically it worked. At least until I restarted my PC and then it did not work. I used the CNC4PC support forum but Arturo was not able to help.
I have read many of the previous posts and never saw this issue. Does anyone have experience with this or a similar issue. Any help would be appreciated.
I installed the card on a Gateway PC runnning windows XP. The device manager shows the card installed and working. Device manager shows 2 I/O address, CD00 and D480. I have tried both with odd results.
When I entered the first address clicked apply Mach3 did not communicate with the card. I then tried the second I/O address and clicked apply and this did not work either. I then went back and input the first I/O address click apply and magically it worked. At least until I restarted my PC and then it did not work. I used the CNC4PC support forum but Arturo was not able to help.
I have read many of the previous posts and never saw this issue. Does anyone have experience with this or a similar issue. Any help would be appreciated.