Hello Guest it is March 28, 2024, 09:47:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - R

Pages: 1
1
General Mach Discussion / Question regarding dsp ,control boards
« on: February 27, 2011, 06:12:39 AM »
Hello, I'm trying to understand the difference between dsp based control systems and mach 3 based motion  control boards. ( this being for laser engravers marketed online).  Most of the Chinese laser engravers provide dsp control but this does not say a lot, and i,m not sure if it is compatable to the mach3 software. I,m familiar with the Mach 3 software but need an explanation regarding Mach based control hardware and other 'dsp,' control boards.

Please advise,

Regards.

Pages: 1