Hello Guest it is March 29, 2024, 04:33:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dispenn

Pages: 1
1
General Mach Discussion / Mach 3 servo
« on: February 20, 2011, 11:11:50 PM »
can someone please help!!! Just received 2 Gecko drives G320X DC servo drive from Kelinginc all is wired up and ready to run but for some reason the codes aren't going to the motors to turn. can someone please configure the setup. Thank you in advance.

Pages: 1