Hello Guest it is October 30, 2020, 03:23:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - andmar2005

Pages: 1
1
General Mach Discussion / DRO tool used
« on: February 19, 2011, 04:33:15 PM »
hello
DRO what number to use in turning the panel to display information the number of offsets used at any given time
such as M6 T01 1911
T01-No tools
11 - used thistle (just at the table for the tool T11), but loads it to the tool T01
M6 - change tools
hi

Pages: 1