Hello Guest it is March 28, 2024, 08:14:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - tthomp1334

Pages: 1
1
Mach3 and G-Rex / Mach 3 loads but will not run
« on: January 09, 2020, 05:39:10 PM »
I had a computer crash and can not get the software to work on the new computer. 32 bitt

It will load but will not work, it will load a file but that is all, reset button or zero axis also do not work.

I am lost as to what to do, have orders and can not cut them

2
General Mach Discussion / Software will load but nothing works
« on: January 09, 2020, 05:06:09 PM »
I had a computer crash and can not get the software to work on the new computer. 32 bitt

It will load but will not work, it will load a file but that is all, reset button or zero axis also do not work.

I am lost as to what to do, have orders and can not cut them

3
General Mach Discussion / Running Mach3 version 2 in windows 7
« on: February 25, 2019, 07:41:49 PM »
I was running the program under windows 95 with no problems and computer crashed, New computer is running windows 7

When loading the software I do not get a prompt to load the port driver and system is not working.

Thanh's
  Milton

4
General Mach Discussion / Another newbie problem.
« on: February 14, 2011, 05:17:01 PM »
Having a problem getting the motors to move, Have watched the video trouble shooting several time and still can not get them to move.

 Using a desk top with Windows XP and Hobby CNC controller.

Did the printer test and it say’s excellent

Double check all the pin outs to make sure they are right.

When I look at the printer port numbers I have two that come up, One is 0378 and under that one is 0778

When I hit the jog button I hear some nose from the motors but they do not move.

Tried running the G code file Road Runner and the motors make different sounds like they are working but no not move.

Also need to note that I was running the router with Turbo CNC and it was working with it.

Thanks for any input.

Milton


Pages: 1