Guest
Show Posts
1
SmoothStepper USB / SS/C32 combo with other bipolar Stepper Drivers ?
« on: March 17, 2012, 11:25:43 AM »
Hi,
I have made the purchase of 3 bipolar stepper drives rated at 3.5 Amps based on the Toshiba TB6560 IC. I am willing to use them with the Smooth Stepper and C 32 board combo which I already have. The C32 has RJ45 cable interface for the drivers and my drivers have 6 points to connect where as the RJ45 has 8 points. Then how do I connect it to the driver? Do I need to keep 2 points in the RJ45 unconnected/Not used ?
The 6 points on my driver are
1] - CP = Step Pulse
2] CP = Step Pulse
3] - DIR =Direction
4] DIR = Direction
5] -ENB = Enable
6] ENB = Enable
I have attached the driver data sheet which the seller gave me.
Other points on the driver are:- 4 for stepper motor(-A,A,-B,B) and 2 for DC power supply (+, -).
I have made the purchase of 3 bipolar stepper drives rated at 3.5 Amps based on the Toshiba TB6560 IC. I am willing to use them with the Smooth Stepper and C 32 board combo which I already have. The C32 has RJ45 cable interface for the drivers and my drivers have 6 points to connect where as the RJ45 has 8 points. Then how do I connect it to the driver? Do I need to keep 2 points in the RJ45 unconnected/Not used ?
The 6 points on my driver are
1] - CP = Step Pulse
2] CP = Step Pulse
3] - DIR =Direction
4] DIR = Direction
5] -ENB = Enable
6] ENB = Enable
I have attached the driver data sheet which the seller gave me.
Other points on the driver are:- 4 for stepper motor(-A,A,-B,B) and 2 for DC power supply (+, -).