1
General Mach Discussion / Newbie. What am I doing wrong?
« on: February 10, 2011, 11:03:33 PM »
Hi all
Can someone give me a run down on creating a gcode please?
I am using cut2d which I have used to create a dxf file and I then use lazycam to open it and post gcode to mach3.
When I open it in mach3 it looks totally different to what I created.
Do I need to set up the tool details and material details in lazycam as well as specifying them already in cut2d?
Thanks
Steve
Can someone give me a run down on creating a gcode please?
I am using cut2d which I have used to create a dxf file and I then use lazycam to open it and post gcode to mach3.
When I open it in mach3 it looks totally different to what I created.
Do I need to set up the tool details and material details in lazycam as well as specifying them already in cut2d?
Thanks
Steve