Hello Guest it is May 12, 2021, 02:42:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Larsson

Pages: 1
1
General Mach Discussion / Stepping problem
« on: February 10, 2011, 10:33:22 AM »
Hi,

I have this problem with the connection between PC<->Driver. You can se how I hooked up the drivers and BoB in the attachment.
The drivers and Bob are supposed to be wired like this: http://www.brundin.biz/images/datasheets/CW230Elschema1.pdf and i cant find anything wrong with my wiring.
If I short-circuit the P2 and GND the motor will step and If I short-circuit P15 (eStop) to ground the eStop gets triggered so it seems like I have a connection.

Lets get to the problem..
When I jog, the DRO is counting but the motors wont move. I hope anyone here could help me

(I have checked the active low checkbox.)

Thanks in advance
Niclas

Pages: 1