Hello Guest it is March 28, 2024, 02:26:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - laconcepts

Pages: 1
1
General Mach Discussion / loading screens etc
« on: February 06, 2011, 08:24:29 PM »
Hello everyone. Today is my first time posting in the Mach forum.
I have a DynaCNC 4X4 plasma/router. I have been doing all plasma to this point but will be starting some routing on my machine soon.
Since the machine was purchaced ready to run I do not much knowledge of Mach3 behiind the sceens. Meaning, ports and pins, motor tuning homing and limits loading screens etc. I have watched several or the training videos and have picked up a good bit of knowledge.
Now... I am wanting to swap out the PCs and need some info on what to move. I attempted it once but did not have any luck so I put the old PC back on.
I need to know where I can find info on how to do the following.
1. What files need to be copied from the old pc and where exactly to each chf them go.. xml, bitmaps.sets, brains (?) and anything else like that for the machine to work like it did before.
2. I have to screens.. One for plasma and one for routing. When making any adjustsments for homing and limits, motor tuning etc.. the settings do not follow from one screen to another. Is this normal?? If not how do I change it.
3. How do I load new screens?? where do all of the files go.
4. Is there any documentation on any of these topics.

The Mach manual doesnt describe any of this and I have spent a few hours doing some searches in the forum but I just havent had any luck finding what Ineed

I sure would appreciate any assistance.
Kelly


Pages: 1