Hello Guest it is October 02, 2023, 08:30:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - jzak3

Pages: 1
General Mach Discussion / how to reset defaults in mach3
« on: September 27, 2012, 06:15:31 PM »
Hello, I used to have a cnc router set up using 1/4 - 20 threaded rod and now I have a new machine with acme 10-2 threads and I would like to know is there a way to reset the defaults in mach3 so I wouldn't have to go through the whole system and try to remember what they were, so if I can reset the defaults I can set up the new machine without having to remove the software and re install it

  Thank you.

Pages: 1