Hello Guest it is July 27, 2021, 05:41:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - fritts

Pages: 1
1
General Mach Discussion / Slave Z to Y Axis??
« on: January 26, 2011, 12:28:26 PM »
Is it possible to slave the Z axis to the Y axis?   I have a 3 axis controller that I want to use to test a plasma cutter.   Is it possible to reassign the pins or slave the Z axis to the Y axis to test the movement as I have 2 steppers on the Y axis and not enough axis on the Stepperworld board to control them.

Thanks

Pages: 1