Hello Guest it is May 31, 2020, 12:56:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - LCorsa

Pages: 1
1
General Mach Discussion / Jogging strangeness
« on: January 27, 2011, 06:59:18 AM »
Hi, everyone. New Mach3 user and fairly new to CNC in general. I have a Romaxx WD-1 with a closed loop system. When first starting up Mach3, I can do continuous jogging and MPG jogging. If I try to do step jogging, all jogging becomes disabled, i.e., continuous and MPG won't work. However, if I then run a toolpath (any toolpath, even for 1 second), all jogging then works fine, including step jogging. I can live with this, just running a toolpath briefly whenever I first start up, but I'm wondering if anyone has ever encountered this behavior and knows of a fix. Thanks, in advance, for any suggestions.
Larry

Pages: 1