Topics

1

Newfangled Mill Wizard / Suggestion for Mill Wizard

« on: May 11, 2014, 05:38:16 AM »

I Like to use mill wizard where possible

I think a mirror function in engrave would be good.
I am deep engraving the rear of acrylic to led light from underneath for a nice LED sign.
But need mirror in engrave please.

Thanks in advance graemecns

2

Newfangled Mill Wizard / Engraving with gcode text from stickfont.2.12 bugs?

« on: July 06, 2013, 05:59:17 AM »

I need the editing a sizing, spacing, fonts and formatting mill wizard does not have.
Found stick font 2.12 which has the flexability can covert fonts to chr format that mill wizard also uses (requires mod in text to display letters in right order in mill wizard)
It generates a gcode which I can add in millwizard looks fine I also add a rectangle around to cut out sign. All looks fine in mill wizard.

Says gcode created. but when I load into mach3 the rectangle is gone and if I try to run code the gcode moves but the DRO oscilates between  0    .0025 mm nothing happens. Is this a bug or am I missing something.?

Thank graemecns