1
General Mach Discussion / How did he / How do I do this?
« on: July 26, 2010, 12:54:06 AM »
I really would like to figure out how this individual was able to make the drill come on for only the down stroke. I understand all the mechanicals but I cannot figure out for the life of me how he programmed it. This could be used for so much more. Compressed air for chip removal, Coolant only coming on when actual cutting is happening.
Not to sound like a penny pincher but think of the cost savings. Lets say you have to drill 2 holes that are 90" apart. The amount of air/coolant that is dumped in-between the 2 cuts is significant.
On the shopbot forum they mentioned modding the PP but what would you add or do to make this happen. Thanks for the help.
http://www.youtube.com/watch?v=o7HK4Lks2J0
Not to sound like a penny pincher but think of the cost savings. Lets say you have to drill 2 holes that are 90" apart. The amount of air/coolant that is dumped in-between the 2 cuts is significant.
On the shopbot forum they mentioned modding the PP but what would you add or do to make this happen. Thanks for the help.
http://www.youtube.com/watch?v=o7HK4Lks2J0