1
General Mach Discussion / "run from here"
« on: January 22, 2011, 10:16:16 AM »
hey gang
Need some help.........
I have this program, an airfoil outline with some spar cut-outs.
It runs very smooth along the arc until I use the "run from here" option.
After that.........the arc is cut in jerky small steps. Nothing I can do changes this. Even ending out of Mach3 and reloading the G code , nothing helps. Its jerky steps from then on.
Someone help me here!!!
Pete in Lower/Slower Delaware
Need some help.........
I have this program, an airfoil outline with some spar cut-outs.
It runs very smooth along the arc until I use the "run from here" option.
After that.........the arc is cut in jerky small steps. Nothing I can do changes this. Even ending out of Mach3 and reloading the G code , nothing helps. Its jerky steps from then on.
Someone help me here!!!
Pete in Lower/Slower Delaware