1
General Mach Discussion / Need a little help on steps per min
« on: July 30, 2011, 12:36:46 PM »
Finally back at my 4 X 8 precision Plasma build, been off of it due to heavy work load.
If I try to cut a 5" X 5" square the Y is 5" but the X is 4 inches. I have all the steps per min the same on the X, Y, and A axis so I can't figure out what is wrong. I verifid the G code as having 5" move ment on all 4 sides.
I'm attaching the XML code (I hope) Thanks Hood for getting me straight on the XML
Thanks for any help
If I try to cut a 5" X 5" square the Y is 5" but the X is 4 inches. I have all the steps per min the same on the X, Y, and A axis so I can't figure out what is wrong. I verifid the G code as having 5" move ment on all 4 sides.
I'm attaching the XML code (I hope) Thanks Hood for getting me straight on the XML
Thanks for any help