Hello Guest it is February 23, 2020, 03:05:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - sagita

Pages: 1
General Mach Discussion / ofset g55
« on: January 13, 2014, 03:19:24 PM »
when i use G55 and i change the Z coordinate to cero and then to 8 or any value  and then cero again to get my new cero on Z. my part does not have the height expected.seems like save the last height on z axis.

i lost my old computer with XP WORKING  without any trouble.

 and now i am using windows 7 32 bits with a  PCI PARALLEL CARD.

motor are configured and the accuracy too.


MACH VERSION 3.043.066

Pages: 1