Hello Guest it is April 11, 2021, 07:05:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Mikka

Pages: 1
General Mach Discussion / Newby needs advice
« on: January 12, 2011, 08:51:11 PM »
Hi, Im new and this is my first post. Im planning on buying a small CNC engraver with Mach3 software built in. I need this for engraving my logo onto rifle barrels. Is there much difficulty involved in getting this software to follow the contour of the round barrel while applying the logo. Im no expert in this area so any advice would be welcome.

Pages: 1