1
General Mach Discussion / "probe tip diameter is invalid"
« on: January 10, 2011, 07:55:53 PM »
Hi,
Been using Mach3 for many years first with a Taig and recently with a Tormach. I recently purchased a used Marposs Probe to replace an econo probe I had for years. The Marposs probe came with a probe tip that is 0.2755" dia. But when I put input this into tool #99, the message of "probe tip diameter is invalid " comes up when I try to probe the vise. I can probe X, Y or Z just fine but not the vise. Can anyone help?
Thanks!
Ken Wu
Been using Mach3 for many years first with a Taig and recently with a Tormach. I recently purchased a used Marposs Probe to replace an econo probe I had for years. The Marposs probe came with a probe tip that is 0.2755" dia. But when I put input this into tool #99, the message of "probe tip diameter is invalid " comes up when I try to probe the vise. I can probe X, Y or Z just fine but not the vise. Can anyone help?
Thanks!
Ken Wu