1
General Mach Discussion / Need help w/ taper milling
« on: January 21, 2011, 02:05:03 PM »
Hi all:
I'm new to "machsupport" and could really use someone's expertise. I need to taper mill a 12" hole with a radius. I have all the Mach3 "wizards" including the pay-to-use ones from "Newfangledsolutions" loaded. All I can find is one for 2d in the lathe section. Any and all help would be greatly appreciated.
Thanks,
BDR70
I'm new to "machsupport" and could really use someone's expertise. I need to taper mill a 12" hole with a radius. I have all the Mach3 "wizards" including the pay-to-use ones from "Newfangledsolutions" loaded. All I can find is one for 2d in the lathe section. Any and all help would be greatly appreciated.
Thanks,
BDR70