Hello Guest it is March 28, 2024, 06:28:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - tony978

Pages: 1
1
I was wondering if there was  digitizing in mach 4 , I can't find anything on it besides stuff for mach 3 . I want to probe my run out on my 4th axis .

2
Mach4 General Discussion / ess probe sanity check
« on: April 27, 2019, 08:44:12 AM »
so I'm have an ess and a c25 with probe . It is powered by a 2 amp 5 volt supply , both ess and c25 are powered by it . I'm not sure why when I connect probe signal pin 13 port 2 to ground it doesn't show tripped in mach . The probe checks out with a meter .  the ess and mach are configured for that pin name to probe . anything I missed ?

3
Mach4 General Discussion / probe error : no contact with probe
« on: April 07, 2019, 04:32:44 PM »
I'm setting up a machine using a parallel  port for the time being and I can't get the probe to function correctly. I've flipped hi/low  settings , the z never moves and either it reads that its tripped or no contact with probe   . Debounce is set to 100. so I'm out of Ideas.

Pages: 1