1
General Mach Discussion / Logitrol and C23 BOB Question
« on: December 24, 2010, 06:35:54 PM »I am in the finish stages of building this contraption and have come upon an issue that I have not been able to resolve. (I am sure due to my lack of knowledge in electronics).
The machine is a gantry router with dual X motors. I purchased a Logitrol 5 axis controller which works fine if connected directly to the parallel port of the PC. I wanted to have a breakout board to give me some more options so I bought a C23 BOB from CNC4PC and installed it between the PC and the Logitrol driver (uses Geckos). I understood that the signals should pass through the board uninterupted, however I cant get anything to move when the board is in the mix.
If anyone has had any experience with this board or similar problems I would greatly appreciate some input .
-10F and project is on hold...(looking for a rope)