Hello Guest it is June 13, 2024, 12:38:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 7654321

Pages: 1
1
General Mach Discussion / how to config z axis HCNC
« on: February 18, 2011, 04:03:47 PM »
how to config z axis HCNC? do I need to program all  fractions or is there a way to set it up properly?
Thanks

2
General Mach Discussion / axes cant decide direction
« on: February 04, 2011, 03:06:55 PM »
axes cant decide direction
when I send all to home somtimes an axis goes in the wrong direction...

3
General Mach Discussion / limits triggered randomly no display
« on: January 16, 2011, 12:12:19 PM »
Finally got the limit switches in Mach 3 to work correctly but now almost randomly all stops as its moving and limit switch error appears and cant reset until I go to settings manual limit reset.
I am wired in series going to gnd and pin 11. Could it be in the home settings. Cannot see anything.No display in Display Mode???

Pages: 1