Hello Guest it is May 10, 2021, 11:49:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - mike345

Pages: 1

Using a SS441 hall device I was able to get closed loop spindle control working using an input on my Gecko G540.  The G540 is controlling the spindle speed via PWM.

Is there a way to trigger an emergency stop if the spindle RPM is significantly different than what is being set?

For example, if I set the spindle to 1000 rpm but the closed loop control sees 0 RPM (or anything under 900RPM) is there a way to make MACH3 do an estop or trigger a fault?

Pages: 1