1
General Mach Discussion / Has anyone replaced an Anilam M control with Mach 3 ???
« on: December 13, 2010, 07:14:42 PM »
I have an M control I've owned since new in 86 and it's time to get a newer more supportable control. I have a Galil 2133 board to interface with my servos. My M uses glass scales in a closed loop system for positioning. Has anyone installed Mach 3 using glass scales?
If possible I'd like to locate anyone near the LosAngeles or Ventura County area that has done a Mach 3 installation and is currently using it. Please send me a PM if you have any info.
Thank You for your time
Michael
If possible I'd like to locate anyone near the LosAngeles or Ventura County area that has done a Mach 3 installation and is currently using it. Please send me a PM if you have any info.
Thank You for your time
Michael