Hello Guest it is March 28, 2024, 02:46:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bad_bunny

Pages: 1
1
General Mach Discussion / Problem configuring plasma table
« on: September 18, 2012, 12:33:03 PM »
Hi,

       Not sure what I am doing wrong. I have Mach3 running to a plasma table and in Mill configuration, everything seems to work and I get proper movement. When I try to use the Plasma configuration the motors do not respond correctly to the hot keys. Anyone else have this problem?

Thanks

Steve

Pages: 1