Hello Guest it is April 18, 2021, 02:24:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - yksur

Pages: 1
1
Hello to all first post, i downloaded and installed mach3 demo to test.
I haven't a cnc router at today but want to learn mach3.
After starting mach3 i load the g-code roadrunner then press cycle start but mach3 run few lines and stop here, time elapsed continue to run and zero x, y is 0.0000 :



i check on ports and pins:



but i haven't no device attached so i unchecked all ports.
 
Is there any chance to run/learn mach3 without a cnc router?

Thanks in advance.



Pages: 1