1
Mach4 General Discussion / Arc ok signal in Mach4
« on: February 12, 2016, 08:45:41 AM »
I have a CSMIO system set up and running.
I will be using in on a small plasma table, I do not want to use THC.
My process is:
Torch moves to position.
Torch moves to pierce height.
Fires torch (m03)
Waits for ARC OK (good arc) ( digital input signals to 1 and 14?)
System pauses for pierce time (g04 p1.0)
Torch moves to cut height
Torch cuts part.
How best do I setup it so that it waits for the waits for "ARC OK" before proceeding?
Many Thanks
I will be using in on a small plasma table, I do not want to use THC.
My process is:
Torch moves to position.
Torch moves to pierce height.
Fires torch (m03)
Waits for ARC OK (good arc) ( digital input signals to 1 and 14?)
System pauses for pierce time (g04 p1.0)
Torch moves to cut height
Torch cuts part.
How best do I setup it so that it waits for the waits for "ARC OK" before proceeding?
Many Thanks