Topics

1

PoKeys / pokeys analog

« on: October 20, 2008, 06:29:26 PM »

any one know how use analog inputs in mach3 for speed override, spindle override, ?
i tried use brain  it recognizes the analog input but i dont know how terminate the rug for implement the two overrides.

Josep.

2

G-Code, CAD, and CAM discussions / Lathe Gcode

« on: March 19, 2008, 08:06:21 AM »

hi..
where can i get a full list of all G and M codes implemented in Mach3 Lathe. I need for customize postprocessor.
i thik in the "using turn manual" are not all codes mach3 using.
 tks. Josep.

3

General Mach Discussion / G95 lathe problem

« on: March 03, 2008, 03:32:15 PM »

hi.
i have problems in my lathe. when i set it in g95 the CSS led never light and the lathe never compensate the feed rate when i up the rpm.
when threading the same ocur i have a litle over rpm  for example when i set to 100rpm i get 127rpm and no compesation is done in the feed rate consecuentliy the thread pitch is minor.
when adjust the rpm via the vfd and i get 100rpm then the pitch is ok whit a litle deviation.
the spindle index pulse is clear and i compared the TRUE DRO whit a profesional tacometer and i found a 2-3 rpm deviation in all range 30 to 2000 of my lathe.
any idea what happend
tks. Josep