1
General Mach Discussion / help to set A axiz for tangencial cut
« on: December 10, 2010, 01:41:43 PM »
Hi
Can anyone help me to set the A axis for tangential cut? What I did was activate the A axis on the motor outputs and under general configuration checked A-axis is angular. Then under settings when I activate tangential control I get the square next to it yellow and blinking. The motor does not make any movement.
What am I doing wrong? Please help
Thanks
Sacramento
Can anyone help me to set the A axis for tangential cut? What I did was activate the A axis on the motor outputs and under general configuration checked A-axis is angular. Then under settings when I activate tangential control I get the square next to it yellow and blinking. The motor does not make any movement.
What am I doing wrong? Please help
Thanks
Sacramento