Guest
Show Posts
1
General Mach Discussion / Random Estoping Kinda
« on: June 03, 2011, 06:51:02 AM »
i have tried everthing in the forum for this issue and still cant fix it . problem is when i activate the y and z limits i cant clear the estop as mach is saying there is a limit switch triggered. but in the diagnostics page none of the l.e.d. are lit. all the switches perform as expected,
-Only happens when y and z limit inputs are active
-they are all wired with shielded cable.
-wired to be active high (y and z)
-tried disabling watch dog and set the debounce interval up to 10000 and no help
-when selecting the Automated setup of inputs and doesent matter what input that is selected mach picks up a signal from port 1 pin 0,
So as far as i know the is no pin 0? i don't get it. all my electronics are from keling.
-Only happens when y and z limit inputs are active
-they are all wired with shielded cable.
-wired to be active high (y and z)
-tried disabling watch dog and set the debounce interval up to 10000 and no help
-when selecting the Automated setup of inputs and doesent matter what input that is selected mach picks up a signal from port 1 pin 0,
So as far as i know the is no pin 0? i don't get it. all my electronics are from keling.